Home Products Assembly Instructions Tradeshow Calendar Contact Us About Us The Bartlett Buzz... Links

3-Tier Display with Wheels

 Assembly Instructions

Required Tools: Tape measure, pencil or marker, 7/16” – 9/16” wrenches or sockets.

The following instructions allow for assembly by one person.

Assembly:

1. Assemble leg pairs – Use one tube that is straight and one that is bent that have the same wheel types.  Hold the tubes together so the wheels are even (both swivel wheels go together and both rigid wheels go together) and put a mark on the bent tube even with the top of the straight tube.  Spread the bottom of the tubes about 40” apart and use a 3-bolt clamp to fasten the legs together as shown in the photo.  Line up the top of the straight tube and the mark on the bent tube with the top of the clamp.

2. When tightening the clamp bolts make sure the tubes are rotated so the wheels are parallel to each other and at a right angle to the ground.  You may need to stand the leg pair up to check this step.

3. Install basket rod – (For units with the double basket rod option, use 3a. below) Using the 1-bolt clamps, attach the basket rod to the top of the legs.  The single leg of the “T” is on the top of the bent tube; the basket rod passes through the top of the clamp, flush with the edge.  The bent tube is at the back of the display and angles toward the front.  Tighten the clamps with the legs parallel.  Stand the legs up to install the shelves.

   1. For Double basket rod option – Using a 1-bolt clamp attach the short (24”) tubes to the top of the taller leg.  Line the ends up over the leg bottoms.  Use 1-bolt clamps to attach the basket rods to the ends of the 24” tubes.

4. Install Support Tubes – Slide two 78” tubes into the widest (bottom) shelf. Slide the tubes into the second mesh in (from the outside edges) of the shelf. Each end should stick out about 3”.

5. Install shelves – Set the widest shelf in place as shown in the photo on the left so the shelf is level (or at some angle you’d like). The tubes of the shelf should come to rest on the outside of the legs.  The placement of the support tubes should put the shelf within 6-9” of the top of the wheels. Make sure both ends are at equal heights and that the legs are still at the angle formed by the 3-bolt clamp at the top of the legs. (Too much weight or pressure on the shelf will cause the legs to move too close together.) Attach the 4-bolt aluminum clamps on each of the four corners of the shelf. The tube placement for the upper shelves can be varied to achieve the height and angle you prefer.  Moving the tubes toward the center of the shelf will raise the height of theshelf and moving them out will lower it.  The tubes do not have to be in matching slots on the shelf.  (One could be in 3 meshes and the other side could be in 2 meshes.)  If you are going to be hanging large baskets on the rod, you may choose to use only 2 shelves, as the spacing can get tight with three shelves and large baskets.

6. Green plastic end caps are available to put into the end or the support tubes. Your display is now complete and ready to go.

One of our main objectives at Bartlett Bench & Wire is to make doing business with us easier for your company. If you have any thoughts, comments or questions that you feel could assist us in achieving this objective, please feel free to let us know. Email us today!